194: HYDRAULIC LIFTING POWER

1

Hello, I am an estimator with Custom Source Woodworking, Inc. We are looking into a project at the University of Washington and they are looking for a 13'9"x4' Lift up door in one of their buildings. I searched high and low for the hardware for this and your company seems to be one of the only ones that might be able to help with this. They are specifically looking for a lift up door that does not get power ran to it. Please let me know if anymore information is needed. Thanks!

2

Looking to get a price on a 29' x 16' high lift door. Opening is 16' and I need all of that

3

We are looking to get a quote on a 42' wide x 14' tall Hydraulic Lift Hanger Door. We have worked with your team in the past but its been a few years.

4

I am looking to quote 2(two)- opening of 10' x 9' high. Will a 8' x 9' tall door work for this? 1(one)- opening of 20' x 10' high. Looking for a 16' x 10' high door Does each door need its own pump or can one pump be shared by all 3 doors? All three will be on the same wall.

5

need a price on a hydraulic lift door for a new aircraft hanger in New Iberia, LA

6

i am looking to build a hangar with a 14 ft tall 45 ft wide hydraulic powered door. can you please price this unit for me.

7

Hello, We are looking for a quote on 5 doors, and we have a welding shop, so we're interested in building the doors ourselves. We would like a quote for finished doors as well as the unassembled. 1 door 52 x18' 2 doors 24 x 18' 2 doors 26 x 18' All doors hydraulic lift one piece, we will provide the insulation and the cladding. Thanks R

8

I see your Schweiss Red Power pumps work on doors that swing down? im planing to make a bar in AR out of a shipping container. what are your suggestions? the door will be made from the cutout of the container ..20 or 40 feet. Will your electric actuator cylinders work for a 40 footer? thanks

9

I need a door with good hydraulic lifting power   for shipping container type installation (not rollup, as no overhead in-board clearance available for roller assembly). Typical opening 8ft high x 10ft wide, manual operation preferred, electrical actuation possible. Insulated alu. skin panels 2" thick. Location Baltimore, MD.

10

Looking to bid an another couple of hanger doors, please quote 1 piece hydraulic aircraft doors. 1) 42' x 12' (2). 110' x 28'. The 110 foot door will need your good hydraulic pump lifting power.